Workshop · June 2026

Camper Roof Rebuild

A slow roof leak rotted the ceiling and roof framing of our travel trailer. I took the roof off down to the walls, rebuilt it, and put a new TPO membrane on top.

Looking up through a camper with the roof removed: new and old rafters against a blue sky with clouds.
Roof off, framing exposed.

The problem

A leak in the roof let water into the ceiling. By the time it showed inside, the ceiling panels were stained and sagging, and the wood above them was soft. Patching the spot wasn't an option once I could see how wet the framing was.

A camper ceiling panel pulled back to show rotted, crumbling roof structure above it.
First look behind the ceiling.
Ceiling removed around a roof vent, showing water-stained decking and damaged framing.
Water damage around a vent.

Constraints

  • Weather: once the roof was open, the inside of the camper was exposed until the deck and membrane were back on.
  • Time: about ten days in mid to late June 2026, with help from family and friends. I put in more than 60 hours myself.
  • Everything on the roof comes back: the AC unit, vents, and wiring all had to come off and go back on, sealed.

What I did

The camper roof from above in 2023, with the original white roof, AC unit, and vents.
The original roof, a few years earlier.
  1. Strip it. I pulled down the ceiling panels and took the roof off down to the walls, so I could see every piece of rotted framing.
  2. Rebuild the framing. I replaced the rotted rafters and framing with new lumber.
  3. Deck it. New OSB decking went over the framing, with openings cut for the vents and AC.
  4. Membrane. A new TPO membrane went over the deck, then the edges and every opening were sealed.
  5. Put it back together. I reinstalled the AC, vents, and wiring, and put up new ceiling panels inside.
Inside the camper with the roof removed, looking up at rafters and open sky.
Down to the framing.
New OSB decking over the camper roof framing, with an opening for a vent.
New OSB decking going down.
The new white TPO roof surface with water droplets on it after rain.
New TPO, the morning after rain.
The finished OSB roof deck from above with a roof vent installed.
Deck on, vents going back in.

How I checked it

  • Seams and sealant: I walked the roof and inspected every seam, edge, and opening before calling it done.
  • Real rain: it rained the day after I finished. I checked inside afterward, and the roof held.

What broke / what I'd change

  • The rot went further than expected. The leak looked like one spot from inside. Once the ceiling came down, the damage was spread much wider, which is why this became a full roof instead of a repair.
  • Next time: inspect the roof seams and sealant on a schedule, so a small leak gets caught before it reaches the framing.
The finished camper parked on grass, seen from the side.
Done.