Workshop · 2020 to 2026

Garage Workshop

The garage became a workshop in two phases: a coated floor and ceiling storage in 2020, then insulation and a real bench area in 2026, so the CNC, hand tools, and computer finally have a home and I can work out there year-round.

Garage workbench: a Shapeoko Pro CNC on a rolling cart beside base cabinets with a countertop, a monitor and laptop, and a pegboard wall of hand tools.
The finished bench area.

The problem

The garage was too hot or too cold to work in for much of the year. The CNC sat on a cart wherever it fit, surrounded by bikes and storage, and the tools didn't have a place.

Before: the CNC on a wooden cart in a crowded garage, next to a bike, a broom, and a tool chest.
Before: the CNC wherever it fit.

Constraints

  • It's still a garage: the shop has to share space with everything else a garage holds.
  • The CNC needs room: it has to be easy to reach from the computer and still move when needed.

What I did

Phase 1, 2020: floor and storage

  1. Prep the concrete. I cleaned the bare floor down before coating it.
  2. Epoxy with color flakes. The floor got an epoxy coating with color flakes.
  3. Hardtop hoist. I mounted an electric hoist to the ceiling to lift the Jeep hardtop up and out of the way when it's off the Jeep.
Bare, wet concrete garage floor during cleaning, with stains and puddles.
July 2020: bare concrete, mid-cleaning.
The finished garage floor: smooth gray epoxy with color flakes.
Two days later: epoxy with flakes.
A Jeep hardtop hanging from a ceiling-mounted electric hoist on yellow straps in the garage, next to storage shelves.
October 2020: the hardtop hoist.

Phase 2, 2026: insulation and bench

  1. Insulate. I put fiberglass batts in the walls and covered them.
  2. Build the bench. Base cabinets with a countertop give me a work surface with storage underneath.
  3. Tool wall. A pegboard above the bench holds the hand tools, so everything is visible and has a spot.
  4. CNC station. The Shapeoko Pro sits on its own rolling cart at the end of the bench, next to a monitor and PC for designing and running jobs.
Garage walls with insulation installed and covered, with tools and the CNC parts on a bench in front.
Walls insulated and covered.

How I checked it

I didn't measure temperatures before or after. The difference is easy to feel, though: the garage is now comfortable enough to work in when it wasn't before. If I did it again, I'd put a cheap temperature sensor out there first and log a few weeks of before and after.

What I'd change

Measure first. A temperature sensor tied into Home Assistant would have turned "it feels better" into a number.